Oil filled radiator is a popular heating equipment, mobile, and relatively safe to use. Especially for those living outside the rental housing group, the use of oil filled radiator in a small space is a good choice. But the appliance must be used correctly, in order to better ensure its safety and prolong its service life. What do you want to pay attention to when using oil filled radiator?
First, the correct use of temperature controller
When the oil filled radiator heater works normally, the temperature controller should not always be set at the highest grade. otherwise, when the working temperature of the heater is close to 110 ℃, the temperature controller is not easy to operate, and the internal devices are easily damaged, aged or damaged due to long-term high-temperature operation. Therefore, when using the oil filled radiator heater for the first time, set the thermostat in place. Adjust, the temperature controller knob clockwise gently rotate to the maximum position, open the two power switch, the whole machine is in the maximum output state, heating up for about 5 minutes, with the back of the hand gently pat on the upper surface of the shell, if feel the temperature is appropriate, the knob counterclockwise direction gently rotate until there is a clear contact pop - up, at the same time, the power supply indicator on the power switch is off, and then clockwise So that the setting is complete, the heater can provide people with satisfactory temperature.
Second, the correct choice of power switch
Oil filled radiator heater uses two groups of sealed electric negative heating tubes as heating elements, two groups of heating tubes corresponding to two grades of two selector switches. At present, the common heater in the market is set to 1500 w and 2000 W.. Under the condition of waiting for the power line to allow, the correct selection of power gear can save electricity, reduce line load. Start to open the heater or indoor temperature is low, open the two-speed selector switch at the same time, the heater quickly heating, the shell surface working temperature reached the set temperature point, the thermostat automatically cut off the power supply, at this time should choose the power of the first or second gear. When the thermostat is reset to power on, it is heated with lower power, gradually increasing the indoor temperature.
Three, pay attention to keep the room sealed
Oil filled radiator heater is in the form of air convection to increase indoor temperature, indoor temperature and affect the power supply on and off. Good indoor sealing, high room temperature, short heating time, long heat dissipation time, thus saving electricity.
Iv. no coverage
The heater works normally, the surface temperature of the shell is higher, generally set about 90 ℃. The temperature control of the heater is realized by the temperature sensing deformation of the metal sheet of the temperature controller in the mask. If the periphery of the heat sink is wrapped and covered in order to bake the clothes, the temperature of the covered heat sink will be significantly higher than the temperature felt by the in-plane bimetallic strip, thus easily baking the clothes and possibly causing damage to the heat conducting elements inside the heater housing.
Five, prohibit upside down or upside down electric heating
A special heat transfer oil is filled in the heater shell, and a certain pressure is arranged inside the heater shell after heating, so that the internal pressure is lower than 0.2mpa during normal use, the heat transfer oil filling amount accounts for about 70 percent of the total volume, and the interior of the heater shell has larger space. Upside down or upside down, the internal heating pipe exposed to the oil surface, in this case, electric heating may produce over-burning rupture, damage to the heating pipe. In this case, be sure to pay attention to when using.
In addition, oil filled radiator is a high-power electrical appliances, if living in an old house, so when using to avoid at the same time have high power electrical appliances in operation, to ensure the normal and safe use of home appliances, so electricity must be careful oh ~